This version of this document is no longer maintained. For the latest documentation, see http://www.qnx.com/developers/docs.

`devn-rlan2.so`

Driver for RangeLanII Ethernet controllers

Syntax:

io-net -d rlan2 [option[,option ...]] ... &

Runs on:

Neutrino

Options:

Use commas (,) to separate the options (not spaces).

channel=num

Channel number. The default is 1 if the card is set to be a master.

did=0xXXXX

PCI device ID. The default is automatically detected on supported hardware.

domain=num

Domain ID. The default is 1.

ioport=num

I/O port of the interface. The default is automatically detected on supported hardware.

irq=num

IRQ of the interface. The default is automatically detected on supported hardware.

lan=num

LAN number. The default is 0.

master=string

Name of radio link if the card is set to be a master.

model=x

p: PCI
c: PC Card
u: MicroISA
i: ISA

mtu=num

Maximum transmission unit. The default (1514) is automatically detected on supported hardware.

pci=0xXXXX

PCI index of the controller. The default is automatically detected on the supported hardware.

priority=N

The priority of the driver thread. The default is 21.

promiscuous

Enable promiscuous mode. By default, it's disabled.

roam=0|1

Roaming enable (0) or disable (1).

type=x

s: STATION
a: ALTERNATE
m: MASTER

The default is ALTERNATE.

verbose

Be verbose.

vid=0xXXXX

The PCI vendor ID of the controller. The default is automatically detected on the supported hardware.

width=8|16

I/O access width (8 or 16 bits). The default is automatically detected on supported hardware.

Description:

The devn-rlan2.so driver controls the RangeLanII Ethernet Controllers.

This driver was added in the QNX Momentics 6.3.0 SP2.

Examples:

Start io-net using the RangeLanII driver and the full TCP/IP stack:

io-net -d rlan2 -p tcpip
ifconfig en0 10.184

Files:

/dev/io-net: The directory where, by default, drivers and protocol modules add entries. For more information, the documentation for io-net.